Signal System of Water Motor Auto Control Driving Machine
| Sound System | |
|---|---|
| Beep (3) times | = T.T.T (Signal Sound of Driving Motor) |
| Beep (7) times | = T.T.T.T.T.T.T (The alarm sound, arrive on electric power under 160 volt and over 240 volt) |
| Intruder Alarm | = Long Pull sound (The alarm sound, not draining water into tank from water pipe top of head or without water ground tank) |
| Sound | = Melody sound (The alarm sound full in water) |
| Indicator System | |
|---|---|
| Motor LED | = Signal bulb when water motor driving If not draining from water pipe head exit, bulb show the signal with twinkle, twinkle. |
| Lower Tank LED | = Bulb show the water in Ground Tank |
| Upper Tank LED | = The bulb show the full water/have water on upper tank |
| Over (or) under LED | = Bulb show the electric power arrive to over (240) volt and under (160) volt. |
| If Lower tank LED only light on, while driving motor the electric power was low and down (or) Not draining water into upper tank (or) have not water in ground tank, in that time, the said bulb will be light on. | |
| To Notice |
|---|
| 1. When Power S/W Light Off, check the fuse. If fuse will cut out, chase to power of motor and change fuse Ampere from fuse data and put in. If the fuse failed in (3)times check the motor with Expert. |
| 2. If Sensor wires out side of controller is cut out, the water motor cannot drive with control. |
| 3. When the motor drive in manual, attached the No. (4) Motor (L) wire to No. (2) A.C (L) wire on terminal Block of Controller Box and fixed the nut and switch off the power s/w of controller box and can be driven. |
| To Notice While Driving With Manual System | |
|---|---|
| (If not have water in Ground Tank (or) not to be drained into over head tank (or) full of water and flood over in upper tank (or) the electric power up and down, the motor will not stop in any cause manual driving make alarm the each beep sound (8) second in one time. |
Compressor Installation
